How should we adjust the metal shredder when soft materials wrap around the cutter?

During the operation of the metal shredder, you are afraid of encountering soft metal materials wrapping around the cutter. If the cutter is entangled with the material, the cutter will be damaged, or it will directly cause the metal shredder to shut down, affecting production efficiency. How to avoid metal shredder tool entanglement? Let me briefly talk to you today. When the cutter of the garbage shredder becomes entangled, Kowloon Machinery Technology recommends that you adjust the speed of the metal shredder cutter slower to increase the bite strength of the cutter to shred these materials quickly.

Timely adjustment of the speed of the metal shredder cutter according to different materials can not only increase the shredding output of the shredder, but also prevent unnecessary wear of the cutter to a certain extent, thereby extending the use time of the shredder. In addition, the daily maintenance of the metal shredder is also important. The shredder must be lubricated before working. Doing so can not only increase efficiency and output, but more importantly, it is also helpful for the maintenance of the machine. If the machine is properly maintained, the use time will be relatively prolonged; it can be adjusted according to the size of the feed inlet. Feed evenly. Materials cannot crowd the crushing cavity. Too much material will cause the metal shredder to shut down due to cutter crushing. Regularly check whether the shredder cutters are stable and have cracks, as well as the wear of the cutters, etc.

The size of metal shredded particles can be determined by the diameter of the mesh.

The metal shredder produced by Kowloon Machinery Technology is an environmentally friendly and energy-saving crushing equipment designed with the concept of energy saving, consumption reduction and emission reduction. It is also a necessary equipment for pre-shredding and pre-treatment of metal reuse. The knife is forged from European imported materials, which is durable and has good crushing effect on metal. The overall structure is compact, low speed, large torque, small vibration, low noise, and meets environmental protection requirements. How to adjust the particle size of scrap metal in the production of shredder? After the scrap metal is shredded, the metal material particles are discharged through the equipment screen. The size of the discharged particles is determined by the screen aperture. Depending on customer needs, the shredded material particles can be controlled by replacing screens with different apertures to ensure uniform discharge. When the materials of qualified size meet the specified particle size requirements, they will flow out along the screen. The unqualified materials will be crushed again in the machine cavity until they are of qualified size and then discharged.

In addition, in order to ensure the uniform discharge of the wheel metal shredder, the following points need special attention during the use and maintenance of the large tire shredder:
1. Users need to regularly check the wear of the metal shredder's consumable parts. If the equipment's cutting tools are severely worn, problems such as poor crushing and low discharge rate will occur, and it will also lead to uneven discharge particle size.
2. Regularly clean the accumulated material inside the crushing chamber of the shredder so that the material can flow out smoothly.
3. Adjust the size of the shredder screen holes to control the particle size of the discharged material.
If you want to know more about the details of GEP's large tire shredder, you can contact us directly and we will serve you wholeheartedly.